The Received Signal Strength Indicator (RSSI) meter is designed to help installers determine the optimum installation site for the USA Technologies’ ePort line of hardware devices.
|
High Gain antenna helps in areas with low signal strength. It requires a 7/16" hole for mounting the antenna on a metal surface.
|
High Gain antenna helps in areas with low signal strength. It requires a 7/16" hole for mounting the antenna on a metal surface. Cable is 4ft in length.
|
High Gain antenna helps in areas with low signal strength. It requires a 7/16" hole for mounting the antenna on a metal surface. Cable is 8ft in length.
|
Standard Gain Antenna for ePort G5,G6 & G7 with SMA connector.
|
Standard Gain Antenna for ePort G8 or ePort EDGE with MCX connector.
|
Extends the current Card Reader serial cable which is generally required when the ePort Controller is not located within six feet of the Card Reader.
|
For tapping into 115VAC power at vendor line filter.
|
Used for tapping into 115VAC in vendors with IEC type power connectors
|
|
|
Connects the EDGE device to the vending equipment's MDB bus.
|
Used to connect the G6/G7 to the Multi Drop Bus (MDB) of the vending equipment.
|
Used to connect the G6/G7 to the Multi Drop Bus (MDB) of the vending equipment.
|
This MDB cable is for use with the ePort G6 and G7 only. This MDB cable will allow you to bring power from the MDB harness instead of receiving from the external power supply.
|
This cable is included with the G6/G7 ePort kit and connects the G6/G7 controller to the 12VDC external power supply.
|
This cable is used to tap into 115VAC in Automatic Products vending equipment.
|
This cable is used to tap into 115VAC in older Dixie Narco vending equipment that has a "StackPlug" in the vendor door wire harnessing.
|
This serial cable is necessary to provide the interface when using a Coinco or MEI Combi Bezel with the G8 Controller as the Telemeter.
|
Used to connect the ePort G6 or G7 to an MEI or Coinco Combi Bezel.
|
Required for Vendo Vue Vendors when installing a G6 ePort or G7 ePort System.
|
Used to audit cash and cashless totals. When this card is swiped, the ePort device is triggered to display cash and cashless totals.
|
This card is used for fill-to-fill reporting. Swiping this card will trigger a fill-to-fill report in USALive for accounting and settlement.
|
Allows a handheld DEX device to retrieve DEX Data along with the ePort System to automatically retrieve DEX Data without removing any cables.
|
Extends the DEX Cable another ten feet whenever the DEX Port is too far away to support the standard six foot DEX Cable. This cable does not replace the existing DEX Cable, it extends it another ten feet.
|
Standard DEX Cable included with each Edge kit. This DEX cable features the 'black' 10 pin (2x5) Molex connector.
|
Optional DEX Cable for the G6 or G7 ePort device whenever DEX retrieval is required.
|
This DEX Splitter Junction Box will allow a Handheld DEX retrieving device to be used with the EDGE ePort System to retrieve DEX Data without removing any cables.
|
Assists when installing an ePort G6 or G7 Controller inside a glass front drink vendor or other type of vendor.
|
The G8 ePort is designed to receive power from the MDB cable harness. This option is for applications that don't supply power to the G8 ePort.
|
This plate is required when installing the RF/Swipe Card Reader in a full bill acceptor opening.
|